When some customer want to use weight model for Vacuum Homogenizing Emulsifier Vacuum Emulsifying Mixer Machine in order to make the super quality personal care product and high automatic control system , have to use the weight model for loading system .but most customer or Vacuum Homogenizing Emulsifier manufacture ignore the weighing module loading system the requirement for base leading to lose the weighing model accuracy. Here is the base requirement for base
A basic installation requirements for Vacuum Emulsifying Mixer Machine
Weighing module loading system foundations are usually divided into two types, concrete foundations and steel structure foundations. In order to ensure good measurement performance, the foundations should meet the following requirements:
1.1 Requirements for concrete foundation for Vacuum Emulsifying Mixer Machine
If there is a concrete foundation below the module, it is generally necessary to arrange the embedded slab in advance. The relevant requirements are as follows:
1. Strength requirements for Vacuum Emulsifying Machine
The concrete should meet the relevant mechanical requirements of the module, and the strength should be sufficient. The specific mechanical requirements depend on the project situation.
2. Dimensional requirements for embedded boards for Vacuum Emulsifying Machine
Generally, it is required to be larger than the lower transition plate of the module, and the welding seam position should be reserved, and the thickness should not be less than that of the transition plate.
3. Flatness requirements of embedded boards for Vacuum Emulsifying Machine
For a single module, the flatness of the installation plane below should be guaranteed, and the maximum angle between a single installation surface and the horizontal plane should not exceed 0.5°, and the height difference between the installation surfaces of multiple modules should not exceed 3mm, which can be leveled by a gasket.
1.2 Basic requirements of steel structure for Vacuum Emulsifying Machine
If there is a steel structure foundation below the module, generally the following conditions must be met:
1. Rigid requirements
Generally, from no-load to full load, the overall flexible deformation of steel structure should be less than 1/1000. If this cannot be met, local strengthening of the steel structure should be considered. Common methods are shown in the figure below.
2. Flatness requirements for Vacuum Emulsifier Machine
For a single module, it should be ensured that the maximum angle between the installation plane below and the horizontal plane is not more than 0.5°, and the height difference between the installation surfaces of multiple modules is not more than 3mm, which can be leveled by a gasket.
Smart Zhitong has many years of experience in the development, design and production of Vacuum Homogenizing Emulsifier Machine, Vacuum Emulsifying Mixer Machine and the machine capacity from 5L to 18000L also Vacuum Emulsifying Mixer Machine Vacuum Emulsifier Machine for loading system
If you have concerns please contact
Post time: Oct-19-2022
